Difference between revisions of "MCU Relay"

From ElectroDragon
Jump to: navigation, search
 
Line 14: Line 14:
 
* Notice when deactive time set to 0 second, will hold the loop, won't quit
 
* Notice when deactive time set to 0 second, will hold the loop, won't quit
 
== Setup Demo ==
 
== Setup Demo ==
 +
* [https://twitter.com/electro_phoenix/status/996246067053285377 Clear Demo Video]
 
* [https://twitter.com/electro_phoenix/status/988328062084317184 A rough demo video for STC MCU relay board could see here], module count down and hold relay status on first loop, then config and loop as configed.
 
* [https://twitter.com/electro_phoenix/status/988328062084317184 A rough demo video for STC MCU relay board could see here], module count down and hold relay status on first loop, then config and loop as configed.
 +
*
 
[[category: Topics]]
 
[[category: Topics]]

Latest revision as of 16:46, 15 May 2018

Use guide

Power on ->"normal mode"

  • Read last config from MCU
  • Start to count, when count to 0, turn on relay
  • LONG press bottom button -> enter into the config mode of "turn on relay"

In the config mode for "the stage of active relay"

  • Short press top button to add one second
  • Short press bottom button to add 50 seconds
  • Long press bottom button to enter into next the config mode of "turn off relay "

In the config mode for "the stage of deactive relay"

  • Short press top button to add one second
  • Short press bottom button to add 50 seconds
  • Long press bottom button to save data, and back to "normal mode"
  • Notice when deactive time set to 0 second, will hold the loop, won't quit

Setup Demo