ESP8266 Flash Firmware

All the relevant items can be purchased from www.electrodragon.com!  items used in here including: ESP-07 with on board status LED (ESP-12 LED will not work for arduino blink sketch) ESP breakout board CH340 USB-TTL programmer breadboard and a few jumper wires. You can find the flash tool on this page. Flashing options in the tool explained

Read More

WS2812 Stick Board Test

WS2812 Stick Board Test

You can find the arduino library in the product link: https://www.electrodragon.com/product/ws2812-neopixels-ring-leds/ https://www.electrodragon.com/product/8-led-ws2812-5050-rgb-led-stick-board/ From the example, run “standtest” sketch, follow the instruction to setup for the board, and it will show all the standard effects: The wiring should be Din – pin6 of arduino, VIN – 5V arduino, GND – GND arduino. And here is youtube

Read More

Flash NodeMCU to Wi07-12 ESP8266 Board

The NodeMcu development board is sold out recently, not sure when the new stock will arrive. The development has some peripheral circuit to ease your usage, including USB-UART, USB5V-3.3V power supply, buttons, and lead out all the IOs. But you can still use the Wi07-12 standalone without the dev board, we use a FT232RL breakout

Read More

ESP8266 GPIO Test (Edited firmware)

To use Update date to now firmware, at commands V1.5: download at commands 1.5V here, if you use 1MB flash for esp-01s or 4MB for esp-12F, etc, etc. can use the combined bin. https://github.com/Edragon/esp_firmware/tree/master/AT Also at commands instruction inside, has GPIO function, need this three. AT+SYSIOSETCFG=13,3,1 AT+SYSGPIODIR=13,1 AT+SYSGPIOWRITE=13,1 — The following content is obsolete, not

Read More