Nanino

From ElectroDragon Wiki

Brief

The Original Design is available here:
http://vonkonow.com/wordpress/2012/10/nanino-the-diy-friendly-arduino
How it looks

BOM List

  • 1x single sided PCB board (etch, mill or order)
  • 1x ATmega328P (28 pin DIL)
  • 1x IC socket 28 pin DIL (optional)
  • 2x 6×1 0.1” female pin header
  • 2x 8×1 0.1” female pin header
  • 1x 6×1 0.1” pin header (FTDI connector)
  • 1x 10k resistor (reset pull up – 1/4W)
  • 2x 1k resistor (power and pin 13 LED – 1/4W)
  • 1x Green 3mm LED (pin 13)
  • 1x Red 3mm LED (power)
  • 1x 16 MHz crystal (0.2” pitch)
  • 2x 18pF decoupling caps
  • 1x 6mm miniature switch (reset)
  • 2x 0.1uF decoupling cap 0.1/0.2”(aref and power)
  • 1x 1uF cap 0.1/0.2” (optional if power is good)

Documentation

File:Nanino8toner.pdf