Difference between revisions of "Arduino-Compatible DIY PTH Board"

From ElectroDragon
Jump to navigation Jump to search
Line 9: Line 9:
 
== Documentations ==
 
== Documentations ==
 
* Schematic - http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Kits/Arduino-Compatible-PTH-v13.pdf, or [[File:Arduino-Compatible-PTH-v13.pdf|here]]
 
* Schematic - http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Kits/Arduino-Compatible-PTH-v13.pdf, or [[File:Arduino-Compatible-PTH-v13.pdf|here]]
* Eagle File - http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Kits/Arduino-Compatible-PTH-v13.zip, or [[File:SFE03-0010-KitCard-ArduinoPTH-ReadersSpreads.pdf]]
+
* Eagle File - http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Kits/Arduino-Compatible-PTH-v13.zip, or [[File:Arduino-Compatible-PTH-v13.zip]]
* Assembly Guide - http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Kits/SFE03-0010-KitCard-ArduinoPTH-ReadersSpreads.pdf
+
* Assembly Guide - http://dlnmh9ip6v2uc.cloudfront.net/datasheets/Kits/SFE03-0010-KitCard-ArduinoPTH-ReadersSpreads.pdf, or [[File:SFE03-0010-KitCard-ArduinoPTH-ReadersSpreads.pdf]]
  
 
[[category: Arduino HDK]]
 
[[category: Arduino HDK]]

Revision as of 02:41, 26 November 2021

Check List

  • First make sure all parts installed correctly
  • Check crystal should be 16M for arduino or similar, (not support by this board 8M) or 8M for arduino pro mini 3.3V/8M
  • Make sure FTDI cable installed in correct direction.
  • On board power LED "ON" should be ON to indicate power supply


Documentations