Difference between revisions of "Arduino GPS Board"

From ElectroDragon
Jump to navigation Jump to search
(Created page with " ===Arduino Demo Code=== * You need to be aware of the baud rate of your GPS, in the code below it is 38400.This baud rate maybe not read avaialble from arduino monitor, then...")
 
Line 6: Line 6:
 
* [https://github.com/Edragon/Arduino/tree/master/Sketchbook/NGS Demo code please this on this page, use hardware or software uart.]
 
* [https://github.com/Edragon/Arduino/tree/master/Sketchbook/NGS Demo code please this on this page, use hardware or software uart.]
  
[[[category: Location SDK]]
+
[[category: Location SDK]]

Revision as of 23:27, 28 June 2020

Arduino Demo Code

  • You need to be aware of the baud rate of your GPS, in the code below it is 38400.This baud rate maybe not read avaialble from arduino monitor, then after you upload the code, you need to open a serial monitor for monitoring.
  • Nema demo will write to uart
  • Connect your GPS shield via hardware uart pin 1/0 or software uart pin 2/3
  • Demo code please this on this page, use hardware or software uart.