Difference between revisions of "Category:OLED"

From ElectroDragon
Jump to: navigation, search
(Board schematic)
(Dimension)
Line 45: Line 45:
  
 
== Dimension ==
 
== Dimension ==
 +
Dimension for OLED with back PCB
 
<gallery>
 
<gallery>
 
File:0.96 oled size.jpg| 0.96'' SPI OLED dimension
 
File:0.96 oled size.jpg| 0.96'' SPI OLED dimension
Line 52: Line 53:
 
File:1.3‘’_OLED_display_iic.jpg | 1.3'' OLED dimension IIC new, for SPI and IIC both
 
File:1.3‘’_OLED_display_iic.jpg | 1.3'' OLED dimension IIC new, for SPI and IIC both
 
</gallery>
 
</gallery>
 +
Dimension for raw OLED
  
 
== Board schematic ==
 
== Board schematic ==

Revision as of 03:30, 8 December 2017

SSD1306 and SSH1106

  • IIC address select, 稳压管 = on board regulator
IIC address.jpg
  • IC compare
Type SSH1106 SSD1306
Display for 1.3 only for 0.96 and 1.3 both
RAM / resolution 132 x 64 128 x 64
address 0x00 0x02
Alternative address for arduino 0x3D or 0x3C, or run a IIC scanner in arduino


Interface

Pin From Left IIC SPI Change from SPI to IIC Arduino Setup
1 GND GND GND
2 VCC VCC VCC
3 SCL D0 - CLK or SCL D13
4 SDA D1 - MOSI or SDA D11
5 X reset D8
6 X data/command select for setting IIC address D9
7 X chip select D10
  • SPI interface, can be changed to IIC
  • To use SPI un-comment U8G2 library line in skech example

U8X8_SH1106_128X64_NONAME_4W_HW_SPI u8x8(/* cs=*/ 10, /* dc=*/ 9, /* reset=*/ 8);

  • To use IIC, un-commen the next line

U8X8_SH1106_128X64_NONAME_HW_I2C u8x8(/* reset=*/ U8X8_PIN_NONE);

Dimension

Dimension for OLED with back PCB

Dimension for raw OLED

Board schematic

New Schematic

Documentation

IC Datasheet

Board Datasheet

Official Arduino Library

Other Library

Post

Tools

This category currently contains no pages or media.