Difference between revisions of "Category:Stepper"

From ElectroDragon
Jump to navigation Jump to search
(Arduino Simple Demo Dode)
(Specification)
 
Line 10: Line 10:
 
* "interleave" means that it alternates between single and double to get twice the resolution (but of course its half the speed).   
 
* "interleave" means that it alternates between single and double to get twice the resolution (but of course its half the speed).   
 
* "Microstepping" is a method where the coils are PWM'd to create smooth motion between steps.
 
* "Microstepping" is a method where the coils are PWM'd to create smooth motion between steps.
 
== Specification ==
 
Size:
 
NEMA 17 is a common size used in 3D printers and smaller CNC mills.
 
=== Examples ===
 
{| class="wikitable sortable"
 
|-
 
! Type !! Step Angle !! Holding Torque Nm !! Drive Voltage !! Nominate Current !! Shaft !! Phase Induction !! Phase Resistance !! Weight !! Length !! Rotor Interia
 
|-
 
| Nema 8 (20mm dia.) ||
 
|-
 
| Nema 11 (28mm dia.) ||
 
|-
 
| Nema 16 (39mm dia.) ||
 
|-
 
| Nema 17 (42mm dia.) || 1.8 || 0.46 || - || 1.7A || - || 4 || 2.1 || 0.28kg || 39.5mm || 55 g.cm^2
 
|-
 
| Nema 23 (57mm dia.) ||
 
|-
 
| Nema 34 (86mm dia.) || 1.8 || 2.4-12 || 24/48V || 4/6A || 14mm dia. 5mm Key|| 3.1-7.8 || 0.5-1 || 2.2-5.2kg || 68-150mm || 1.92-4.57 kg.cm^2
 
|}
 
  
 
== Documentation ==
 
== Documentation ==

Latest revision as of 01:46, 17 May 2021

Find the phase sequency

  1. Connect the comm pin to VCC
  2. Connect one of the rest wires to the GND, if the motor jumps once, then let's say it is A
  3. Let's then try the rest of the wires except comm. and A, if one the wire connects to GND and the motor move clockwise then Let's say it is B.
  4. Repeat the step 3, until you find C, D, E....
  5. Finally, you can programm your stepper in sequence AB--BC--CD--DA--AB or (AB / B~A / ~A~B / ~BA / AB)

Stepper Drive Methods

  • "Single" means single-coil activation
  • "double" means 2 coils are activated at once (for higher torque)
  • "interleave" means that it alternates between single and double to get twice the resolution (but of course its half the speed).
  • "Microstepping" is a method where the coils are PWM'd to create smooth motion between steps.

Documentation

Pages in category "Stepper"

The following 9 pages are in this category, out of 9 total.