Difference between revisions of "MCU Relay"

From ElectroDragon
Jump to: navigation, search
Line 12: Line 12:
 
* Short press bottom button to add 50 seconds
 
* Short press bottom button to add 50 seconds
 
* Long press bottom button to save data, and back to "normal mode"
 
* Long press bottom button to save data, and back to "normal mode"
== Setup Demo ===
+
== Setup Demo ==
* [https://twitter.com/electro_phoenix/status/988328062084317184 A rough demo video could see here], module count down and hold relay status on first loop, then config and loop as configed.
+
* [https://twitter.com/electro_phoenix/status/988328062084317184 A rough demo video for STC MCU relay board could see here], module count down and hold relay status on first loop, then config and loop as configed.
 
[[category: Topics]]
 
[[category: Topics]]

Revision as of 12:34, 15 May 2018

Use guide

Power on ->"normal mode"

  • Read last config from MCU
  • Start to count, when count to 0, turn on relay
  • LONG press bottom button -> enter into the config mode of "turn on relay"

In the config mode for "the stage of active relay"

  • Short press top button to add one second
  • Short press bottom button to add 50 seconds
  • Long press bottom button to enter into next the config mode of "turn off relay "

In the config mode for "the stage of deactive relay"

  • Short press top button to add one second
  • Short press bottom button to add 50 seconds
  • Long press bottom button to save data, and back to "normal mode"

Setup Demo