Difference between revisions of "Nuvoton"
Jump to navigation
Jump to search
(→Specification) |
|||
| Line 22: | Line 22: | ||
== Specification == | == Specification == | ||
| + | [[File:Ne76e003 spec.png|thumb|right]] | ||
* 1T / 8051: 1T Value Microcontroller, 8051 We are more familiar with the classic kernel; | * 1T / 8051: 1T Value Microcontroller, 8051 We are more familiar with the classic kernel; | ||
* 18KB Flash ROM: better than 8KB Flash, and 18KB of flash space, all can be used as data storage space; | * 18KB Flash ROM: better than 8KB Flash, and 18KB of flash space, all can be used as data storage space; | ||
| Line 35: | Line 36: | ||
* TSSOP20 / QFN20; | * TSSOP20 / QFN20; | ||
* ESD & EFT: HBM / 8KV MM / 400V, Over 4KV, excellent ESD and EFT, immunity to interference and ESD protection; | * ESD & EFT: HBM / 8KV MM / 400V, Over 4KV, excellent ESD and EFT, immunity to interference and ESD protection; | ||
| − | |||
| − | |||
== Schematic == | == Schematic == | ||
Revision as of 05:26, 13 August 2019
Toolchain
Animation setup
Upload bootloader by Nulink and use serial upload, animation
Connect pins 3.3V, CLK, DA, RST, GND to board, should only use 3.3V for n76e003, auto detect IC.
Post process job for hex2bin
- Post-process job, run hex2bin to convert hex to bin for serial download
C:\Users\Administrator\Desktop\N76E003串口下载工具\hex2bin\hex2bin.exe .\Output\GPIO.hex
Programmiing
- Upload LOROM an APROM use ICP tool
- upload later APROM use NuvoISP tool
Serial Download Note
- Need run hex2bin to convert bin file, MCU only support BIN download
- Please use above post build method for bin file when compile.
- need reset/repower MCU before and after flash.
Specification
- 1T / 8051: 1T Value Microcontroller, 8051 We are more familiar with the classic kernel;
- 18KB Flash ROM: better than 8KB Flash, and 18KB of flash space, all can be used as data storage space;
- Same 1024B SRAM
- 17 + 1 inputs: better than up to 16 GPIOs;
- 2xUART, I2C, SPI: Better than SPI / I2C / UART (one more UART);
- 8ch of 12bit ADC: better than 5ch 10bit ADC;
- 6ch of individual duty PWM: better than 3 PWM outputs;
- 10KHz LIRC for WDT reset / WKT;
- 16MHz HIRC ± 1% Room temp. ± 2% full condition;
- -40 to 105 ℃ wider temperature range;
- 2.4V to 5.5V wider supply voltage range;
- TSSOP20 / QFN20;
- ESD & EFT: HBM / 8KV MM / 400V, Over 4KV, excellent ESD and EFT, immunity to interference and ESD protection;
Schematic
- Full schematic tiny board - File:NuTiny-SDK-N76E003 V1.0.pdf
- Development Board Manual - File:UM NuTiny-SDK-N76E003 EN Rev1.00.pdf
- Below schematic, crystal part should be wrong, nuvoton n76e003 use powered crystal.
minimum schematic
